Today I begin by making the brakes lines going from the fusleage exit to the caliper. Nothing very difficult.



The lower part is routed around the wheel axle this will allow enough play as the caliper is moving during braking. Along the gear leg, the tubing is protected by small PVC hose parts. Some electric tape will hold everything inc position during final assembly.



Then I begin working on the front wheel, which was not completed. I take of the wheel and will also take off the fork as I intend to modify it slightly but I first have to do some research on that, so it will next time.



I also installed the engine mounts. The parts are the same but the assembly sequence is different between the upper and lower mounts. The compression points are not the same. It's visible by increasing the size of the picture (see the parts with the small yellow line).