Now that the wires are installed in the rear fuse I have to fasten them somehow, and the only solution to do this is to crawl into the back of the fuse.
After some efforts, the strobe wire is secured against the stringer (on the left of the picture).
The other wires route via the bottom of the fuse and through the frames. They will be secured via tywraps installed in some square support that I have prosealed in place. One is visible just aft of the bend in the orange wire holder and there are to more on the right side of the picture.



This is how the strobe wire is routed along the stringer.



As I had some more proseal, I glued on the terminal strip for the nav lights.



Working time on this subpart
Today :  3h (Total : 62h)