Still working on the routing af all the wires. On the right side, I begin by sleeving the wome wires in th engine compartment.



I then tackle the wiring on the right side.
There are also some sidetasks : wire markings, some crips to do...



The forrest of tabs fills slowly.

To be able to connect all the boxes and parts, I need to know how the wires will be routed to be sure they are not too short. So I installed semi permanently some of the harnesses.
The left side looks good, but some wires are still missing.



The center needs some more work.

Today, I reinstalled the VFH and the trnasponder in the panel. Tomorrow I will install the headset plugs. I will then have almost all the wires in the cabin and be able to tackle the routing and the connexions.

Before beginning soldering the headset plugs, I first finish the transponder harness. The altitude encoder DSUB gets installed as well as the markings of all the wires. Fifteen more wires finished.



I then begin soldering the plugs. One has to be careful to which pin is used, how many wires there ar to solder , not forgetting the heatshrink.



This are all the wires.

No pictures today but I cut and marked th wires for the intercom and there are quite a few. Next task will be to solder the wires to the plugs.