I first reinstalled the auxiliary battery and clamped down the harness below.



I then made some nicer harnesses to the forrest of tabs. I still have some work to do on the harness running below the forrest of tabs, but first I will have to clamp down the harnesses climbing from the floor along the firewall.

Today I fabricated a few small brackets that will allow to bolt the c-clamps used to hold the harnesses. The picture shows a few of them.



And this picture shows the brackets riveted to the rib. The c-clamp will be installed later.



After having reconnected some wires I had to disconnect yesterday, I worked on the wires running along the firewall under the auxiliary battery and under the forrest of tabs.
The picture shows the wires after the battery has been removed.



To hold all the wires, I installed two small brackets on the auxiliary battery box.

Still working on the right side, I had to un plug quite a few wires to get some decent runs. I have three more wires to run correctly and they are long ans soldered, I'll see tomorrow how I will arrange them.

I have to tidy up the harnesses on the right. As this side has the buses and the intercom, there are a lot of wires. At initial installation I was a bit sloppy with how a run the wires ans so I have to reopen some harnesses that I had already finished. But slowly I'm approaching the finished product.

I go on trying to tidy up the wire harnesses. I have to install platenuts (hence drilling, dimpling....), make some small brackets a lot of small time consuming tasks.
This show the left side between the firewall and the subpanel.



This is behind the subpanel, not finished yet.