All the parts are now primed, riveting will be next

As I Intend to do some priming I decide to have a few more parts ready, so I decide to install the bagage bulkheads. The upper one has to be cut to shape so I first make a cardboard template.



Here the parts are installed, I then drill the holes all around.



Well here is some not so good result. The hole indicated by the arrow should ne be there. In fact the two upper holes in the rounded bulkhead are not symetrically drilled. I had seen that on the plans, but I was doing my measurments from the back of bulkhead with the dimensions from the front, so my offsets are on the wrong side. I'm sure that if I had been asked to put a hole in alignment were that one is, I would have messed it up. Well, I'll wait for Vans' input on this one.
Anyway, the two bulkheads got primed.

No pictures today, I managed to get the skins deburred and dimpled.

Next step for the fuselage, was to deburr and dimple all the parts. I managed to deburr and dimple the bulkheads and all the small parts. I also deburred the inside of the skins. I the removed the blue plastic from the exterior, I still have to deburr this side and dimple the skins.

Today I installed and drilled the upper skins. Two stiffeners and one rib are also installed. Here the forward part of these parts shown on the picture.