Due to some other projects, the workshop is somewhat idle, it's also a bit to hot to work there. I managed however to update the wiring schematics.

Quite a few wires are running along the floor from the back of the plane towards the panel. So I try to make some nice bundles.
These are the magnetometer harnesses ties with lacing tape.



These are center holes through the main bulkhead below the fuel valve.



And the wire runs towards the firewall were the wires go up towards the rear of the panel.



The wires coming throug the side holes also have to be routed to the firewall. The picture shows the work partially done (the connections will be covered with heatshrink later).

Today I decided to wire the trim indicators. Both indicators are connected to a common D-sub where the wires from the servos will get connected.



The wires from the elevator trim servo are slightly short, I isnert another Dsub. The servo wires come from the left, three of them go from the right side to the indicator and two are fed by the yellow wires to move the servo.

Still working on the routing af all the wires. On the right side, I begin by sleeving the wome wires in th engine compartment.



I then tackle the wiring on the right side.
There are also some sidetasks : wire markings, some crips to do...



The forrest of tabs fills slowly.

To be able to connect all the boxes and parts, I need to know how the wires will be routed to be sure they are not too short. So I installed semi permanently some of the harnesses.
The left side looks good, but some wires are still missing.



The center needs some more work.