All the parts prepared yesterday got sanded, and as expected, looking at the parts made new pinholes appear. All have been filled, or I hope so.

After a light sanding, I fill all the fiberglass parts. There are three that need no work, the others go from a few pinholes to an allmost complete rework. I use this filler from b]Polyfiber[/b] which is easy to use, cures rapidly and is highly visible. I should have used it earlier.



I also filled the pinholes on the cowls, in fact therre were very few.

Today I primed the cowls. The surface is quite large. I sprayed a thin layer of primer so that all the spots that need to be refilled and resanded are highly visible.
All in all, the cowls don't look that bad but there are a few spots , mainly the edges and around the tighter curves that I will have to resurface.



This is a spot that needs to be reworked.

After a little sanding, I prime all the parts. Some look good, but some still have pinholes so I did only a thin layer of primer, then I will fill the holes and prime again.

Sanded again all the parts, including spinner and nose leg fairing. Filled soma e very small holes.