I fabricated and installed the support bracket for the antenna wires. The picture shows one I made for the transponder antenna wire. In the background the four tubings I also connected to the angle of attack CPU.
I also did some lacing.

I finished the wiring on the fuseblocks, I almost finished the wiring behind the subpanel.

At last I had some time to work on the fuseblock wiring. I did some lacing and connected some loose wiring before noticing I had not wired the 12V cigarette lighter plug.



So I run the two needed wires. To insert the wires in the already done harnesses I use a spoonlike tool that is invaluable.

I fabricated a new bracket for the clamp and installed the other clamps around the panel rib lightening hole.

I first installed the shells on the connectors where they were missing. I then could clamp down the harnesses on the subpanel.
The picture shows the two C-clamps and on the left one of the d-sub connexions.



I then finished wiring the intercom and the audio mixer. I also modified the audio output wiring of the GPS, this will allow for easier rewiring depending on the outcome of the investigation on my GPS (answer in a few days).



I will have to modify the support bracket for the clamp that will hold the harness as it routes trough the rib hole, the wires might chaff against the hole edge.